how do i remove the emitter from the star board

red_robby · Sep 21, 2003

can anyone help /ubbthreads/images/graemlins/help.gif I just killed a Q3J /ubbthreads/images/graemlins/mecry.gif
I managed to get the leads of the board, using a soldering iron & a razor but when I tried to get the rest...
the clear cap (with the leads) came right off /ubbthreads/images/graemlins/mad.gif
any suggestions?

MR Bulk · Sep 21, 2003

Desolder leads, grab each side of the board (as close as you can to the emitter base) with two pairs of stout pliers and bend backward, emitter should pop right off.

lambda · Sep 21, 2003

Red,

After you unsolder the leads, bend the heatsink back away from the Luxeon with a couple pair of pliers. Once the aluminum bends, the thermal epoxy holding the Luxeon will seperate and the Luxeon will fall right off.

Edit: Charlie's faster on the draw; go figure....

red_robby · Sep 21, 2003

THANK YOU, THANK YOU, THANK YOU !

red_robby · Sep 21, 2003

if this works, i should have a dorcy 1 AAA with a...
provided it lets go this time.

MR Bulk · Sep 21, 2003

...with a -- what? I would just make sure the driver in the Dorcy is ready to handle a Luxeon...

red_robby · Sep 21, 2003

well, it worked...
those jewelry classes paid off...
i'd post pictures, but i don't know where...
can i have a temporary host?

how do i remove the emitter from the star board

red_robby

Enlightened

MR Bulk

Flashaholic

lambda

Flashlight Enthusiast

red_robby

Enlightened

red_robby

Enlightened

MR Bulk

Flashaholic

red_robby

Enlightened

Similar threads

Latest posts