muddrunner198
Newly Enlightened
- Joined
- Apr 21, 2011
- Messages
- 34
I dont have the equipment to machine aluminum. I was wandering if any body has used lead to make a heat sink. Its readily availabe and can easily be machined with a dremel tool.
Question about heat sink for 2d mag mod
- Thread starter muddrunner198
- Start date
Help Support Candle Power Flashlight Forum
my opinion is that it is a horrible material to use. it has a lower thermal conductivity (35 where as aluminum is 230 and copper is 400), it has a lower volumetric heat capacity (so it warms up faster), and it is very dense (a lead HS will weigh 4 times that of an aluminum HS).
also, you know, it is kinda poisonous
also, you know, it is kinda poisonous
