EzGoingKev
Newly Enlightened
- Joined
- Jun 20, 2009
- Messages
- 23
I saw this thread here. I did not want to hijack it though.
I have an older Fenix TK11 that I use in the shop. I had it under a car while I was welding and got some spatter/slag on it and that messed up the coating.
My questions are:
Is it possible to get a lens with the coating only on one side so it can be installed on the inside so when I weld with it again I do not mess up the coating?
What are you guys using to disassemble the head? I can modify a set of snap ring pliers, but if there is something that will work better I would like to know.
Thanks.
I have an older Fenix TK11 that I use in the shop. I had it under a car while I was welding and got some spatter/slag on it and that messed up the coating.
My questions are:
Is it possible to get a lens with the coating only on one side so it can be installed on the inside so when I weld with it again I do not mess up the coating?
What are you guys using to disassemble the head? I can modify a set of snap ring pliers, but if there is something that will work better I would like to know.
Thanks.