Need help - installing oregonshooter L1 tailcap

Zot · Sep 19, 2011

Can someone please help? I have an oregonshooter L1 tailcap. When I tried to install it, I couldn't figure out how. It looks like I have to remove what is on the tailcap first. I did a search but I couldn't find anything. Where can I find installation instructions? Thanks.

scout24 · Sep 19, 2011

Zot- The retaining ring that holds the boot down on the stock L1 tailcap needs to be removed first. Leatherman, or small needlenose pliers should do the trick. Mine was very stybborn, I had a hole in my left index finger for a week or so from the pliers when they slipped. Be sure to use a dish towel or something similar to hold the tailcap...

Zot · Sep 19, 2011

Thanks Scout24. Does it need to be heated?

DM51 · Sep 19, 2011

No heat needed - it just unscrews, as scout24 says. It's not difficult - even I have managed to do it, lol.

Zot · Sep 19, 2011

OK. So just needle nose pliers and a dish towel to stop the bleeding then?
:grin2:

scout24 · Sep 19, 2011

That should do it! makes a wonderful addition to the L1, IMHO, and works on my A2 as well. Tailstanding is good, and less if any accidental activation!

Need help - installing oregonshooter L1 tailcap

Zot

Enlightened

scout24

Flashaholic

Zot

Enlightened

DM51

Flashaholic

Zot

Enlightened

scout24

Flashaholic

Similar threads

Latest posts