My Olight M21X-Warrior

matthewcyho

Newly Enlightened
Joined
Jul 22, 2011
Messages
130
Location
Hong Kong
After i put my Olight M21X-Warrior into the water , I think the waters get into the LED and the Reflector , After i clean all the water , but the LED still turns on and give me the hight output , but i don't know why, after i put back the reflector and the front cap and twist it back .... After one or two days, and i check the front cap , i don't know why there have some steam on the front cap's class , so how can i solve that problem > ?
 

herosemblem

Enlightened
Joined
Apr 2, 2011
Messages
355
Location
Yolo, CA
Unscrew all the flashlight pieces you can (using only your hands).
Fill a small Tupperware container with rice.
Put flashlight stuff in rice. Close lid.
Wait a few days.

The rice absorbs the water :).
 

matthewcyho

Newly Enlightened
Joined
Jul 22, 2011
Messages
130
Location
Hong Kong
I just put some uncooked rice on the LED , i will wait a few days , and hope it won't have the steam again !! :shakehead
 

2100

Enlightened
Joined
Apr 4, 2006
Messages
897
Location
SINGAPORE, South East Asia
Why not just buy some silica get, if you do not have a dry box? Faster/more effective.

You can also take out the front glass, run the light in medium. The insides will dry very fast due to the heat.
 

herosemblem

Enlightened
Joined
Apr 2, 2011
Messages
355
Location
Yolo, CA
What I meant was this:

Fill the small container (almost all the way full) with dry, uncooked rice.
Unscrew the flashlight tailcap and the head, then put all 3 pieces in the rice.
Put lid back on container, wait a few days.

I hope you didn't actually put a few grains of rice inside the flashlight :). That would be "fun" to clean out!
 
Top