scott011422
Newly Enlightened
- Joined
- Feb 5, 2008
- Messages
- 104
Hey all, I have a Fenix P3D with a burnt up led in it. I was thinking about replacing the led. Anyone know what led it uses??
Opinions on bad Fenix P3D
- Thread starter scott011422
- Start date
Help Support Candle Power Flashlight Forum
Are you sure it's the LED?
Standard procedure for a light that won't tun on (in case you don't know):
Clean all threads and contacts, try freshly charged or primary batteries
Make sure the retainer ring in the tailcap is screwed all the way in - you can double-check tailcap clicky malfunctions by shorting the back of the last battery to the body with a paper clip or a key.
Standard procedure for a light that won't tun on (in case you don't know):
Clean all threads and contacts, try freshly charged or primary batteries
Make sure the retainer ring in the tailcap is screwed all the way in - you can double-check tailcap clicky malfunctions by shorting the back of the last battery to the body with a paper clip or a key.
scott011422
Newly Enlightened
- Joined
- Feb 5, 2008
- Messages
- 104
Yep, Quite sure. Led turned black and started smoking...........
Glock27
Enlightened
What caused it to smoke? I'd be afraid to replace the LED as it might be the board that failed and your new one might smoke too.
G27
G27
