Jan 28, 2012 #1 kyhunter1 Flashlight Enthusiast Joined Oct 15, 2008 Messages 1,502 Location South East KY I need 2 or 3 bare XPE R3's for a custom Malkoff project. I need them fast and would rather not go thru Cutter or a larger vendor at this time. :help:
I need 2 or 3 bare XPE R3's for a custom Malkoff project. I need them fast and would rather not go thru Cutter or a larger vendor at this time. :help:
Jan 28, 2012 #2 think2x Flashlight Enthusiast Joined Jul 3, 2009 Messages 1,581 Location Pulaski, Va. You can get them from Illumination Supply on 20mm boards and heat them off easily.
Jan 28, 2012 #3 kyhunter1 Flashlight Enthusiast Joined Oct 15, 2008 Messages 1,502 Location South East KY Thanks for the tip, but Im afraid I will overheat and destroy them. What is the best way to do it?
Jan 28, 2012 #4 think2x Flashlight Enthusiast Joined Jul 3, 2009 Messages 1,581 Location Pulaski, Va. PM incoming
Jan 28, 2012 #5 kyhunter1 Flashlight Enthusiast Joined Oct 15, 2008 Messages 1,502 Location South East KY Thanks for the advice think2x, Im going to give it a try since Craig has the XPE board's I need in stock.
Thanks for the advice think2x, Im going to give it a try since Craig has the XPE board's I need in stock.
Jan 28, 2012 #6 think2x Flashlight Enthusiast Joined Jul 3, 2009 Messages 1,581 Location Pulaski, Va. No problem, if you need anything just PM me.