Jetbeam E3s w/ Nitecore EX11 clip help

NM08SRT8

Newly Enlightened
Joined
Jul 7, 2011
Messages
97
Can someone explain a little what I need to do to make this clip fit? I know there is filing needed but don't want to mess this up and make it look like crap.


Also, I know the lanyard holes are threaded, do the supplied screws with the clip go right in with no problems?


Thanks everyone!


Sent from my iPhone 4s using Tapatalk
 

think2x

Flashlight Enthusiast
Joined
Jul 3, 2009
Messages
1,581
Location
Pulaski, Va.
I found this review on amazon using "Jetbeam E3S EX11 pocket clip" in Google.

5.0 out of 5 stars Great fit for Jetbeam E3S, September 5, 2011By John D Kraft - See all my reviewsAmazon Verified Purchase(What's this?)This review is from: Titanium Alloy Clip for NiteCore EX11 and IFE1 flashlights

I don't have a nitecore EX-11, but this clip fits very well into the pre-tapped holes on a Jetbeam Element E3S flashlight. It did require some widening of the holes in the clip (I just drilled them out a bit), and then provided screws fit perfectly. It's a nice springy clip with just the right amount of tension.

Help other customers find the most helpful reviews
Was this review helpful to you? Yes NoReport abuse | PermalinkComment Comment
 
Last edited:
Top