Thread of T40CS
- Thread starter jh333233
- Start date
Help Support Candle Power Flashlight Forum
Nope not the stainless steel bezel ring
The "thread" between heatsink fins, right above the selection button
I remember that in your review you can open it and reach the emitter but i didnt know whether it is done through bezel ring or you actually have the whole reflector-bezel unit removed
I will post a pic later since postimage.org is acting odd
Thanks again!
The "thread" between heatsink fins, right above the selection button
I remember that in your review you can open it and reach the emitter but i didnt know whether it is done through bezel ring or you actually have the whole reflector-bezel unit removed
I will post a pic later since postimage.org is acting odd
Thanks again!
In this pic:
The emitter is accessed as per my prev. reply; remove the SS Ring then lens then reflector. The surrounding "blackness" you see is actually the head of the light but not obvious since I got in close for this macro.
I am not able to remove the head from the section that houses the mode switch (although they do look like they are two distinct components). It's likely threadlocked.
Hope that helps.
Tim
The emitter is accessed as per my prev. reply; remove the SS Ring then lens then reflector. The surrounding "blackness" you see is actually the head of the light but not obvious since I got in close for this macro.
I am not able to remove the head from the section that houses the mode switch (although they do look like they are two distinct components). It's likely threadlocked.
Hope that helps.
Tim
