Cooper_GTI
Newly Enlightened
- Joined
- Apr 12, 2011
- Messages
- 50
Is it possible to use a TK45 battery holder in my 2D rop mag?
I know that it uses 8xAA's in series, giving around 12v, but i could use 7 cells to really power that 3584!
Getting it to fit into the mag is no problem, as i have already measured up and it will fit with a bit of persuasion thanks to a lathe.
I'm more concerned about the circuit board on the end, and also whether there is a positive and negative terminal on either end?
I know that it uses 8xAA's in series, giving around 12v, but i could use 7 cells to really power that 3584!
Getting it to fit into the mag is no problem, as i have already measured up and it will fit with a bit of persuasion thanks to a lathe.
I'm more concerned about the circuit board on the end, and also whether there is a positive and negative terminal on either end?
