Tiresius
Enlightened
So far, I've managed to get the head partially completed. My current issue is threading. I do not have the proper sized thread bits to thread the head.
http://i707.photobucket.com/albums/ww77/zeron18/IMAG0338_zps6f1a78ac.jpg
The head is partially attached with tape and will be enclosed once I know how to thread a bezel ring onto the top with a 19.8mm UCL. Yes, the lens I purchased are actually 19.8mm, not 20mm like they said. I bored the head for 20mm and it slipped around
Here's another shot:
http://i707.photobucket.com/albums/ww77/zeron18/IMAG0339_zps828dfa74.jpg
Your images are too large and have been replaced with links Please resize and repost.
See Rule #3 If you post an image in your post, please downsize the image to no larger than 800 x 800 pixels. - Thanks Norm
Parts used so far:
carclo 20mm optic (Clear, Narrow)
Cree XM-L T-5 @ 14mm board
Shiningbeam 2.8a driver (3-mode)
Aluminum heat-sink
6061 Aluminum that came in at 1-1/4"x24"
http://i707.photobucket.com/albums/ww77/zeron18/IMAG0338_zps6f1a78ac.jpg
The head is partially attached with tape and will be enclosed once I know how to thread a bezel ring onto the top with a 19.8mm UCL. Yes, the lens I purchased are actually 19.8mm, not 20mm like they said. I bored the head for 20mm and it slipped around
Here's another shot:
http://i707.photobucket.com/albums/ww77/zeron18/IMAG0339_zps828dfa74.jpg
Your images are too large and have been replaced with links Please resize and repost.
See Rule #3 If you post an image in your post, please downsize the image to no larger than 800 x 800 pixels. - Thanks Norm
Parts used so far:
carclo 20mm optic (Clear, Narrow)
Cree XM-L T-5 @ 14mm board
Shiningbeam 2.8a driver (3-mode)
Aluminum heat-sink
6061 Aluminum that came in at 1-1/4"x24"
Last edited by a moderator: