Sold/Expired WTB: Britelumens MIL Spec Finned and Fluted MagD Head

Hi all,

Title says it all. I'm looking a MagD head like the ones for sale in this old thread: http://www.candlepowerforums.com/vb...HA-III-MAG-host)-***-4th-Batch-(COMPLETED)***

Obviously I'll buy the whole light off you as a mag tube without a head is a bit useless. I plan on Cerakoting it so light scuffs and scratches are OK but dents and anything that would show up after coating are not.

Please let me know what you have.

Thanks!

- Matt

Bumpity bump.

If you don't find one I can cut one for you.
$55.00 + Shipping for the whole Mag.

Jesus Hernandez said:

If you don't find one I can cut one for you.
$55.00 + Shipping for the whole Mag.

Click to expand...

So would you be able to fin and flute it just like the picture in post #2 of this thread? http://www.candlepowerforums.com/vb...OMPLETED)***&p=2967100&viewfull=1#post2967100

I've looked through your tri-bore thread and have seen some examples but they're not quite right - britelumens uses fairly fat flutes on his. If you can get it exactly like the one above I'm all for it.

Oh and to be an extra pain I plan on using a tail switch so I don't want the body cut down to the usual 1D - I'd want it cut down like the one on the left in this pic:




...actually even shorter than that - probably just the length of the gripped section should be exposed.

I can discuss this in PM if you like as that be more appropriate. The finning and fluting are the most important parts.