Maxtorch        
Results 1 to 4 of 4

Thread: Zebralight SC600 Not working properly

  1. #1
    Flashaholic
    Join Date
    Jun 2001
    Location
    MI
    Posts
    118

    Default Zebralight SC600 Not working properly

    After a few months of owning it, my SC600 no longer changes modes properly. Low/med/high work, but the sub modes in each level no longer do. I am able to get the secondary level on high to switch to strobe, but nothing else. As a result, the low and med modes stay on the same mode despite the double clicking. Has anyone else had this problem?

    Thanks

  2. #2
    Enlightened NCF8710's Avatar
    Join Date
    Jan 2012
    Location
    Connecticut
    Posts
    57

    Default Re: Zebralight SC600 Not working properly

    I have one of these, but have not seen this problem. It's possible that the control chip is defective. Did you try removing and reinserting the cell? This will reboot it if there is a lockup condition. Otherwise, you should contact the manufacturer for assistance. Good luck.
    I'm an admitted flashaholic, but haven't enough posts to make it official. Keep your powder dry and your batteries charged!

  3. #3

    Default Re: Zebralight SC600 Not working properly

    Quote Originally Posted by NCF8710 View Post
    Otherwise, you should contact the manufacturer for assistance. Good luck.
    Zebralight gives 12 months warranty on their products, that should be plenty to get your light back going good luck!!

  4. #4

    Default Re: Zebralight SC600 Not working properly

    Yeah, 12 months, but I would add that they have honoured the warranty on an H501 past the 12 months for me. So even if it was a little past the warranty period it would still be worth enquiring. In your case of course that isn't an issue anyway.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •