Zebralight SC600 Not working properly

Aaron · Oct 22, 2012

After a few months of owning it, my SC600 no longer changes modes properly. Low/med/high work, but the sub modes in each level no longer do. I am able to get the secondary level on high to switch to strobe, but nothing else. As a result, the low and med modes stay on the same mode despite the double clicking. Has anyone else had this problem?

Thanks

NCF8710 · Oct 23, 2012

I have one of these, but have not seen this problem. It's possible that the control chip is defective. Did you try removing and reinserting the cell? This will reboot it if there is a lockup condition. Otherwise, you should contact the manufacturer for assistance. Good luck.

shelm · Oct 23, 2012

NCF8710 said:
Otherwise, you should contact the manufacturer for assistance. Good luck.

Zebralight gives 12 months warranty on their products, that should be plenty to get your light back going good luck!!

RedForest UK · Oct 23, 2012

Yeah, 12 months, but I would add that they have honoured the warranty on an H501 past the 12 months for me. So even if it was a little past the warranty period it would still be worth enquiring. In your case of course that isn't an issue anyway.

Zebralight SC600 Not working properly

Aaron

Newly Enlightened

NCF8710

Newly Enlightened

shelm

Flashlight Enthusiast

RedForest UK

Flashlight Enthusiast

Similar threads

Latest posts