Nichia 219's everywhere!

I am finally finished. I have converted all but one of my XP-G lights to Nichia 219's.





Now I need to figure out a way to stuff two 219's into my Zebralight SC600 to replace that yellow XM-L. Any suggestions?

Maybe talk to nailbender to see if he will sell you a linger special mcpcb

Nice! I can't get over this LED.
Don't mind the slight visual decrease in brightness at all.
The sunlight tint more than makes up for it.

THE_dAY said:

Nice! I can't get over this LED.
Don't mind the slight visual decrease in brightness at all.
The sunlight tint more than makes up for it.

Click to expand...

I agree. I've put it into several lights myself too.

glockxj said:

Maybe talk to nailbender to see if he will sell you a linger special mcpcb

Click to expand...

Oh man, I have never seen that drop in before. That's exactly what I would need! I mean, if the LEDs were wired up in parallel.

Erik1213 said:

Oh man, I have never seen that drop in before. That's exactly what I would need! I mean, if the LEDs were wired up in parallel.

Click to expand...

They are parallel, I had an XP-G neutral 5000k tint once (before the Nichia) and I'm considering getting on with the 219's now.

Nice lights BTW.

think2x said:

They are parallel, I had an XP-G neutral 5000k tint once (before the Nichia) and I'm considering getting on with the 219's now.

Nice lights BTW.

Click to expand...

I may have to do a little measuring and see if two 219s will fit in the middle of a SC600 reflector with minimal cutting of the reflector.

Thanks! I'm going to gift one tomorrow.