chrisbright
Newly Enlightened
- Joined
- Jun 10, 2011
- Messages
- 13
After a year as EDC, the tail has split right round, just above the threads, and is now in 2 pieces - a threaded sleeve with no end, and an end with the pocket-clip but no threads. The alloy is extremely thin where it split.
Any way to get a replacement end?
Previously the lanyard ring hole wore through and became useless. I used the 2 screws that hold on the pocket clip, to also hold on a small piece of sheet steel with a hole for the lanyard. This worked well, though it would now candle-stand only on the edge of a table etc, where the new sheet steel could project over the side.
Thanks
Chris
Any way to get a replacement end?
Previously the lanyard ring hole wore through and became useless. I used the 2 screws that hold on the pocket clip, to also hold on a small piece of sheet steel with a hole for the lanyard. This worked well, though it would now candle-stand only on the edge of a table etc, where the new sheet steel could project over the side.
Thanks
Chris