I hope I've posted this thread in the right section.
I have a very early Surefire (Laser Products) Round Body 6P flashlight. I was wondering if the new custom P60 type dropins will fit in this light. It doesn't have the removable bezel ring. The bulb assembly drops in from the rear once you remove the head. I was planning on retaining the push for "momentary activation" / twist to activate "constant on" tailcap too. Would also love to hear suggestions as to whether I should limit how far I go with my dropin choice. Any help would be greatly appreciated. Thanks.
This is the dropin I had in mind: EDCPlus X60L 1-mode Warm White T4 Cree XM-L Drop-in For SureFire
Specs: • Powered by Cree XM-L T4 Warm White 80 CRI • Modes: 1 Mode (High) • Current: 1.5A +/- 100mA • Input Voltage: 3-6v • Supported...
I have a very early Surefire (Laser Products) Round Body 6P flashlight. I was wondering if the new custom P60 type dropins will fit in this light. It doesn't have the removable bezel ring. The bulb assembly drops in from the rear once you remove the head. I was planning on retaining the push for "momentary activation" / twist to activate "constant on" tailcap too. Would also love to hear suggestions as to whether I should limit how far I go with my dropin choice. Any help would be greatly appreciated. Thanks.
This is the dropin I had in mind: EDCPlus X60L 1-mode Warm White T4 Cree XM-L Drop-in For SureFire
Specs: • Powered by Cree XM-L T4 Warm White 80 CRI • Modes: 1 Mode (High) • Current: 1.5A +/- 100mA • Input Voltage: 3-6v • Supported...
Last edited: