What 17670s have you used in the Quark 2xCr123 body?

mmace1 · Jun 19, 2013

As the title says - what 17670s have any of you sucessfully used (i.e. they fit) in the Quark 2xCr123 body? Thanks.

Apologies if this should be in batteries, but if it should be, I'm sure it shortly will be moved there.

Ti²C · Jun 20, 2013

the sanyo 16650 protected fits fine in my quarks although the real lengh is more about 68/69mm than 65mm due to the protection circuitry.

LightWalker · Jun 20, 2013

My AW 17670 fits, it's pretty snug but has gotten Better over time, I use to have to take the tailcap off to get it out but now I can sling it out enough to pull it out. A little sandpaper would probably make it slide right out.

Lighteous · Jun 20, 2013

Like LightWalker, I use an AW 17670 in my Quark 123-2 XM-L model. The fit is snug but manageable. The same AW 17670 does not fit in my Quark 123-2 XP-G model, however. I haven't tried sandpaper as suggested, but I don't use that light very often anyway.

reppans · Jun 20, 2013

I'm also using an AW 17670, but in a 2x123 Turbo tube (from a Turbo-X) - my cell slides in/out just by tipping the tube. The Turbo tube exteriors are a touch wider and the 2x123 tube seems to be the same 0.86" as the regular (small) heads and tails.

What 17670s have you used in the Quark 2xCr123 body?

mmace1

Enlightened

Ti²C

Newly Enlightened

LightWalker

Flashlight Enthusiast

Lighteous

Enlightened

reppans

Flashlight Enthusiast

Similar threads

Latest posts