More Power Please
Newly Enlightened
- Joined
- Feb 8, 2013
- Messages
- 5
then re-threading would a 1 7/16thx20 TPI tap meet the pitch. I read that the pitch is 1.43"x20 tpi which ~converts to 1 7/16th. Would that tap work? Thanks
D Cell Maglite rear cap thread pitch question for those cutting the lights down and
- Thread starter More Power Please
- Start date
Help Support Candle Power Flashlight Forum
More Power Please
Newly Enlightened
- Joined
- Feb 8, 2013
- Messages
- 5
Trying again on this one. Would this tap work to put new threads in a Maglite tube that has ben cut down. Thanks
It is not a well regarded option:
http://www.candlepowerforums.com/vb/showthread.php?361120-tap-for-mag-light-end-cap
http://www.candlepowerforums.com/vb/showthread.php?361120-tap-for-mag-light-end-cap
http://www.candlepowerforums.com/vb/...ning-Available
Many would say that's the best way to get a Mag shortened (or a shortened Mag)
Many would say that's the best way to get a Mag shortened (or a shortened Mag)
Similar threads
