PoliceScannerMan
Flashaholic
Up for grabs is a ML1 extreme. Previous owner had it on keys, which wore the edges on the body, the light is smooth with no sharp knurling or edges.
It looks like a user, but has a new label and has a ton of life in her.
Installed an Oveready Ti Shroud.
Has an XPE R2 behind an optic on a copper heatsink, this puppy is a thrower!
The head puts out 263L on high, 10 on low. 15 clicks makes it put out 10L on low and 1L on low, super mizer mode! The head is also E-daptiple. 80 clicks I think.
It runs on the Elm firmware, I will double check that.
SOLD $200 shipped USA/PP
Next up is a SF LX2 with a dedome XM-L2 on copper pushed at 2.8A, done by Vin
The body was bored by none other than Barry at PrecisionWorks, and it has a Ti Shroud from Oveready.
This light is a user, but it is bright with a low of about 4-5L. Nice.
Price $180 now $160 shipped SOLD
USA/PP only at this time, first I'll take it here or PM gets it, thanks!!!
It looks like a user, but has a new label and has a ton of life in her.
Installed an Oveready Ti Shroud.
Has an XPE R2 behind an optic on a copper heatsink, this puppy is a thrower!
The head puts out 263L on high, 10 on low. 15 clicks makes it put out 10L on low and 1L on low, super mizer mode! The head is also E-daptiple. 80 clicks I think.
It runs on the Elm firmware, I will double check that.
SOLD $200 shipped USA/PP
Next up is a SF LX2 with a dedome XM-L2 on copper pushed at 2.8A, done by Vin
The body was bored by none other than Barry at PrecisionWorks, and it has a Ti Shroud from Oveready.
This light is a user, but it is bright with a low of about 4-5L. Nice.
Price $180 now $160 shipped SOLD
USA/PP only at this time, first I'll take it here or PM gets it, thanks!!!
Last edited: