Eagletac D25 series driver/light engine removal

supra1988t · Nov 14, 2013

Anybody know how to remove the driver/light engine from the Eagletac D25 series? I have a Ti clicky that I would like to put a High CRI emitter in. I have heard of people just doing it through the bezel but I am green with a soldering iron and would prefer to get the pill out for easier access, plus Id like to anodize the entire body. Its hard to tell if its pressed/glued in or threaded. Any experience with these is helpful.

Thanks

lebox97 · Nov 15, 2013

good question -
you'd probably have better luck of answer if this were posted in the modders section?
perhaps a MOD will move it for you.

but, I personally would just contact EagleTac at [email protected] and have them swap out the LED for you (for a nominal fee), that way you keep the 10 year warranty on it.

Cheers
Tod

Eagletac D25 series driver/light engine removal

supra1988t

Newly Enlightened

lebox97

Enlightened

Similar threads

Latest posts