Hi all,
I've recently made a Ultafire SK98 clone with an MT-G2 with a 4.5a 3 mode driver (H-M-L), however as with most custom lights they are only able to change modes by half-pressing the switch, which can only be done after the light is powered on..
Is there a way to set the mode of the light before it's even powered on? With dual switches to enable 2 mode groups? (maybe group 1 is 100% only, group 2 is 30% or 1% or strobe )
Eg, for some other commerical lights, they have two switches (or triggers?) that will determine the mode, for example, loosened head will enable either m-l or strobe when powered on, and fully tightened head will straightaway output 100% when powered on
Cheers!
I've recently made a Ultafire SK98 clone with an MT-G2 with a 4.5a 3 mode driver (H-M-L), however as with most custom lights they are only able to change modes by half-pressing the switch, which can only be done after the light is powered on..
Is there a way to set the mode of the light before it's even powered on? With dual switches to enable 2 mode groups? (maybe group 1 is 100% only, group 2 is 30% or 1% or strobe )
Eg, for some other commerical lights, they have two switches (or triggers?) that will determine the mode, for example, loosened head will enable either m-l or strobe when powered on, and fully tightened head will straightaway output 100% when powered on
Cheers!