Hi all,
This was a personal light that I made this summer.
I built it for the made from scratch competition.
Its knurled from tip to tail, lest the fins and a few grooves on the tail cap (what can I say I like the stuff).
The battery in the picture is for size reference and NOT included in the sale.
The head is now sealed but here is a shot of the light engine.
As you can see its fully equipped with a copper core for maximum heat transfer.
The entire body is made from thick wall aluminum, and TYPE III HARD anodized.
There are a couple imperfections on the finish.
A slight bit of wear on the edge of the fins.
Where the knurl ends on the tail cap.
And a little wear where the switch retainer threads in.
The reflector is an orange peel with a soft beam and good balance of flood and throw.
Price is $275>$245>$225 Shipped. SOLD
PP is [email protected]
This was a personal light that I made this summer.
I built it for the made from scratch competition.
Its knurled from tip to tail, lest the fins and a few grooves on the tail cap (what can I say I like the stuff).
The battery in the picture is for size reference and NOT included in the sale.
The head is now sealed but here is a shot of the light engine.
As you can see its fully equipped with a copper core for maximum heat transfer.
The entire body is made from thick wall aluminum, and TYPE III HARD anodized.
There are a couple imperfections on the finish.
A slight bit of wear on the edge of the fins.
Where the knurl ends on the tail cap.
And a little wear where the switch retainer threads in.
The reflector is an orange peel with a soft beam and good balance of flood and throw.
Price is $275>$245>$225 Shipped. SOLD
PP is [email protected]
Last edited: