tobrien
Flashlight Enthusiast
SOLD: Milkyspit "Project-M Extreme" modded KL2 head (quad XP-G) ($150 TODAY ONLY!)
SOLD for $150!
$150 for the next 24 hours only!!!
this is a direct catch and release from this thread. This module is the exact same condition as I received it, except that the tape has been secured again and isn't peeling anymore!
It comes with the KL2's original (now removed) Surefire PCB with LEDs and the bezel ring. It's a two mode (high/low) head with four XP-G R5 1C LEDs behind optics. The beam is really quite a big wall of light. The CPFer I bought this from measured 900 lumens on high in his sphere!!!
Tale of the tape: X1004.4 4x CreeXP-GR51C Tina-XP-D Acorn 1.3 fw:'C-Steamboat'
I'm only selling this because it fluctuates slightly at first turn-on in high, goes down in lumens, and then goes back up again. I was advised by the guy I bought it from that this is normal for Milky's drivers as per his discussion with Milkyspit.
Pictures:
Price: SOLD $170 shipped and insured via Priority Mail in the USA
SOLD for $150!
$150 for the next 24 hours only!!!
this is a direct catch and release from this thread. This module is the exact same condition as I received it, except that the tape has been secured again and isn't peeling anymore!
It comes with the KL2's original (now removed) Surefire PCB with LEDs and the bezel ring. It's a two mode (high/low) head with four XP-G R5 1C LEDs behind optics. The beam is really quite a big wall of light. The CPFer I bought this from measured 900 lumens on high in his sphere!!!
Tale of the tape: X1004.4 4x CreeXP-GR51C Tina-XP-D Acorn 1.3 fw:'C-Steamboat'
I'm only selling this because it fluctuates slightly at first turn-on in high, goes down in lumens, and then goes back up again. I was advised by the guy I bought it from that this is normal for Milky's drivers as per his discussion with Milkyspit.
Pictures:
Price: SOLD $170 shipped and insured via Priority Mail in the USA
Last edited: