Possible to bore M600 Surefire to 18650???

PursuitSS · Feb 12, 2014

I've searched and searched but can't find whether the Surefire M600 Scout Light can be bored 18.5mm so a 18650 can be used.

Will it lose to much of the structural integrity to bore it that far out?

HarryN · Feb 13, 2014

Hi, we are not supposed to cross post, but perhaps a moderator will move your question to this CPF sub forum specific to machining.

http://www.candlepowerforums.com/vb...ted-Materials-Mechanical-Machining-Discussion

If you have a dial calipers or similar to take an exact external measurement, it will help. If the wall thickness goes below 1 mm anywhere, it gets dicey, not impossible, but "exciting".

Tana · Feb 13, 2014

Definitely possible, like boring any other E2E/E2D body... However, considering intended use of M600 setup, I wouldn't even think about experimenting...

But I'm a well known anti-boring activist for e-series anyway...

Possible to bore M600 Surefire to 18650???

PursuitSS

Newly Enlightened

HarryN

Flashlight Enthusiast

Tana

Flashlight Enthusiast

Similar threads

Latest posts