Phredd
Enlightened
When I first got my first Titans, I machined the tail caps to so they would tail stand. I just bought a couple more T1A's before they disappeared. I don't have access to a lathe anymore, but 3D printing is the next best thing. I made a tail stand that clips onto the Titan T1A tailcap.
It works well. I still need to make a couple tweaks. There's a small gap (.04) when it snaps in, it needs to be a little wider and the nubs get sheared a little each time it's pressed on to the Titan.
I made this at Shapeways for about $5. If there's any interest, I'll make it public after it's perfected.
It works well. I still need to make a couple tweaks. There's a small gap (.04) when it snaps in, it needs to be a little wider and the nubs get sheared a little each time it's pressed on to the Titan.
I made this at Shapeways for about $5. If there's any interest, I'll make it public after it's perfected.