capt. crunch
Newly Enlightened
- Joined
- Jun 16, 2014
- Messages
- 1
Hi all, first time post here.
I'm just wondering if anyone could point me in the right direction with regards to disassembling a LED lenser P14? Specifically removing the metal heat sink piece with the LED from the tube section. Is it press fit, tacked in or threaded?
I found a mod on this forum posted a few years back regarding replacing a resistor in the LED base mount and it seems like the tip of the mount is shaped to take a small spanner head but obviously I don't want to try and pull it apart if it is press fit and not threaded. I'd like to replace the resistor to improve the output as per the modification I found.
Cheers.
I'm just wondering if anyone could point me in the right direction with regards to disassembling a LED lenser P14? Specifically removing the metal heat sink piece with the LED from the tube section. Is it press fit, tacked in or threaded?
I found a mod on this forum posted a few years back regarding replacing a resistor in the LED base mount and it seems like the tip of the mount is shaped to take a small spanner head but obviously I don't want to try and pull it apart if it is press fit and not threaded. I'd like to replace the resistor to improve the output as per the modification I found.
Cheers.