Thinking about building a scratch built pen light "smoothy" , and have not been able to find a small enough switch boot.
I think I have everything else figured out, but how to switch it.
I have found switches small enough, just no boots.
Looking at ~12.5-12.8MM ID of my end cap, so the switch boot needs to be around 12MM OD.
Any ideas where to find them??
Thanks,
Jim
I think I have everything else figured out, but how to switch it.
I have found switches small enough, just no boots.
Looking at ~12.5-12.8MM ID of my end cap, so the switch boot needs to be around 12MM OD.
Any ideas where to find them??
Thanks,
Jim