rammertide07
Newly Enlightened
- Joined
- Mar 4, 2015
- Messages
- 3
Hey everyone (or whoever reads this anyways), first time poster. Little about what I do, I do vinyl decals on the side of my full time job. I know very little about el panels except it works off phosphorous and electrical current. Few questions:
Can this be cut with something such as a vinyl cutting machine?
What do you use to seal the panel once it is cut? I'm thinking something along the lines of 3M edge sealer
Where can I buy raw panels with no wire?...and how do you place the wire into the el panel?
That's it for now, thanks in advance!!
Can this be cut with something such as a vinyl cutting machine?
What do you use to seal the panel once it is cut? I'm thinking something along the lines of 3M edge sealer
Where can I buy raw panels with no wire?...and how do you place the wire into the el panel?
That's it for now, thanks in advance!!