HorizontalHunter
Enlightened
- Joined
- Nov 22, 2015
- Messages
- 312
I have an early Fenix P3D flashlight that is about 8 years old. IIRC it has the Cree lamp. The power output is very low and the lowest setting is like a moonlight setting. I have cleaned, lubricated and tightened the tail piece. I have also bypassed the tail cap switch to no avail.
i like this flashlight enough to have it fixed but I have been unable to get any information on getting it repaired out of the Fenix service department.
What do you guys suggest?
thanks,
bob
ETA:
I heard back from The service department and the only parts that they have for the P3D are the switch components.
i like this flashlight enough to have it fixed but I have been unable to get any information on getting it repaired out of the Fenix service department.
What do you guys suggest?
thanks,
bob
ETA:
I heard back from The service department and the only parts that they have for the P3D are the switch components.
Last edited: