Robocop
Moderator, *Mammoth Killer*
I have read a few posts here on removal of the Dorcy AAA reflector and found some say they forced it out the front by simply pushing from the rear.
I have destroyed two heads trying to force this thing out and eventually cut it out with a Dremel cut off wheel.
There has to be an easier way...could not tell if epoxy was used but there was no way I was going to push these out the front.
Any suggestions from someone who was successful with this.Maybe something I could soak the head in to loosen any epoxy?I am using these reflectors in other lights as they are pretty good if smoothed out a little.
I have destroyed two heads trying to force this thing out and eventually cut it out with a Dremel cut off wheel.
There has to be an easier way...could not tell if epoxy was used but there was no way I was going to push these out the front.
Any suggestions from someone who was successful with this.Maybe something I could soak the head in to loosen any epoxy?I am using these reflectors in other lights as they are pretty good if smoothed out a little.