Chippy_boy
Newly Enlightened
- Joined
- Oct 8, 2013
- Messages
- 17
Hi
I have an old Fenix E35 (not the UE) that I'd like to use with my Enerpower 18650's but they are a really tight fit, even after removing the label. I am worried I won't be able to get the cell out, once I have pushed it in fully.
Is it possible to remove the tallcap on an E35? I have tried turning it as hard as I can, but can't get it to budge. I'm reluctant to use pliers for fear of marking the barrel.
You'll remember the E35 doesn't have a tail switch, so there's nothing to unscrew on the inside.
Any suggestions?
I have an old Fenix E35 (not the UE) that I'd like to use with my Enerpower 18650's but they are a really tight fit, even after removing the label. I am worried I won't be able to get the cell out, once I have pushed it in fully.
Is it possible to remove the tallcap on an E35? I have tried turning it as hard as I can, but can't get it to budge. I'm reluctant to use pliers for fear of marking the barrel.
You'll remember the E35 doesn't have a tail switch, so there's nothing to unscrew on the inside.
Any suggestions?