Looking for single mode 3 amp driver
- Thread starter Nitroz
- Start date
Help Support Candle Power Flashlight Forum
http://www.international.mtnelectro...ute=product/product&path=67_116&product_id=52
In options you can choose at the bottom Single mode...[emoji6]
In options you can choose at the bottom Single mode...[emoji6]
ChrisGarrett
Flashlight Enthusiast
I don't know Bud, as I'm only an English Lit major, but here you go:
http://www.mtnelectronics.com/index.php?route=product/product&product_id=52
I don't see an absence of LVP, but good luck.
If this place fails, check over on BLF, as those guys are nuts.
Chris
alpg88
Flashlight Enthusiast
- Joined
- Apr 19, 2005
- Messages
- 5,329
what kind of driver are you looking for? linear, boos, buck?
if it's linear, than you need 8amc driver with mo mc. however all amc drivers have low voltage cut off, not protection, they just can't work below 2,8v iirc.
if you know what you doing you can cut few lines on circuit board of 5 mode amc driver and disable mc and modes, but i do not know which lines to cut
if it's linear, than you need 8amc driver with mo mc. however all amc drivers have low voltage cut off, not protection, they just can't work below 2,8v iirc.
if you know what you doing you can cut few lines on circuit board of 5 mode amc driver and disable mc and modes, but i do not know which lines to cut
Thanks! alpg88! I think that should do it. It's nice that it does not have a controller as my application does not need it.
alpg88
Flashlight Enthusiast
- Joined
- Apr 19, 2005
- Messages
- 5,329
your welcome.
however keep in mind, voltage cut off is build into amc chips themselves, not mc.
Thanks!
