Klarus        
Results 1 to 4 of 4

Thread: How to measure resistance in batteries ?

  1. #1
    Flashaholic*
    Join Date
    Mar 2003
    Location
    Atlanta, GA
    Posts
    1,181

    Default How to measure resistance in batteries ?

    I have looked everywhere for some guidance trying to measure resistance of 18650. What i found is use a resistor in series with the 18650. Is this correct ? Take the voltage of battery only then voltage and resistor measure that then some formula and that gives the actual battery resistance.
    My question is, is this correct and is there a way to use a multimeter only and not use a resistor ? also what value resistor is needed ? 4 ohm or 5 ohm or what is best for a 18650.
    Appreciated.

  2. #2

    Default Re: How to measure resistance in batteries ?

    i have the same quetion i cant wait for the answer
    LED's have gotten too bright in our stuff. Many nights I'm awakened by my modem lights blinking.had help with my sig thank you for your help.

  3. #3
    HKJ's Avatar
    Join Date
    Mar 2008
    Location
    Copenhagen, Denmark
    Posts
    9,319

    Default Re: How to measure resistance in batteries ?

    My website with battery, charger, usb reviews, comparisons & information: https://lygte-info.dk/
    Latest addition is multimeter reviews

  4. #4
    Flashaholic* hiuintahs's Avatar
    Join Date
    Sep 2006
    Location
    Utah
    Posts
    1,819

    Default Re: How to measure resistance in batteries ?

    Forum member HKJ probably has a better answer, but being an EE, what needs to happen is to use ohm's law. V/I = R. Since you can't actually put a DVM on the resistance that is inside the battery, you can measure the voltage at the terminal of the battery before putting any current into the battery and then measure the voltage at the battery while charging. It will be higher. The voltage at the battery when charging has to be higher than the actually battery voltage to over come the internal resistance so that current will flow into the battery.

    That difference divided by the charge current is the internal resistance.

    Vbattery (when charging) - Vbattery (when not charging) / charge current = battery resistance.

    Note that the battery voltage will be increasing when charging so you need to be prepared to make that measurement the moment you start charging.

    Here is a diagram:



    The 1 ohm resistor is put there just so you can measure the current. If you have another way of measuring the current then the 1 ohm resistor isn't needed, such as a good power supply with accurate meter or even another DVM in series with the battery. Voltage measurements need to be made right at the battery terminals and not any distance from the battery or you'll be picking up resistance of the wire. Power supply voltage of 4.20v doesn't need be exact........just a value that will cause a decent current to flow.

    Edit: I just looked over HKJ's link and he has a couple of different examples worth looking over. He's showing how to measure using current flowing out of the battery whereas I did it using current flowing into the battery.
    Last edited by hiuintahs; 02-11-2019 at 01:04 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •