Hi all,
This is a host I made back years ago when I was experimenting with making shorty mags, and head finning. The head fins have an extra set of angles cut at the bottom as a design I tried. The relief cut that is made for the O ring in the tail cap was cut a little to large so a fatter oring would be needed for a tight seal. The finish is good accept for a couple very small dings. It comes with a switch, 26650 body sleeve and short spring installed. $50 USA shipping is free, world wide is $22.
Paypal is [email protected]
Please pay first and then post your "I'll take it in the thread"
This is a host I made back years ago when I was experimenting with making shorty mags, and head finning. The head fins have an extra set of angles cut at the bottom as a design I tried. The relief cut that is made for the O ring in the tail cap was cut a little to large so a fatter oring would be needed for a tight seal. The finish is good accept for a couple very small dings. It comes with a switch, 26650 body sleeve and short spring installed. $50 USA shipping is free, world wide is $22.
Paypal is [email protected]
Please pay first and then post your "I'll take it in the thread"
Last edited: