The Fenix-Store        
Results 1 to 3 of 3

Thread: SBT90.2 Mag 2D Mod

  1. #1

    Default SBT90.2 Mag 2D Mod

    Hallo Together,

    several years ago I successfully modded a 6D Mag with an SST90.

    With the leftovers of this built I now want to do a mod of a 2D Mag with a SBT90.2 LED. Therefore I am going to do drive it with two of these drivers which I am planning to drive in parallel to power the SBT90.2 up to 16 Amps:
    FET 8x7135 Driver Board from K...n

    Means: every 28650 cell is getting an own driver witch is wired up to the switch.

    Are there any constraints/ problems to do so before I frie everything up?!

    Thanks ahead
    Frank
    Last edited by firstlordofthefire; 03-04-2021 at 11:07 AM.

  2. #2
    desert.snake's Avatar
    Join Date
    May 2017
    Location
    Eastern Europe
    Posts
    1,056

    Default Re: SBT90.2 Mag 2D Mod

    Just need to monitor the LED temperature, if the switches used can handle 16 amps.

  3. #3

    Grinser2 Re: SBT90.2 Mag 2D Mod

    Quote Originally Posted by desert.snake View Post
    Just need to monitor the LED temperature, if the switches used can handle 16 amps.
    thanks a lot for your fast reply! I will mod fhe original switch and hope for the best in terms of my heatsink (I will glue the chip directly onto my sink without a star with silver 2k glue)!

    I will post some pictures when I am done!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •