SBT90.2 Mag 2D Mod

[firstlordofthefire]

Hallo Together,

several years ago I successfully modded a 6D Mag with an SST90.

With the leftovers of this built I now want to do a mod of a 2D Mag with a SBT90.2 LED. Therefore I am going to do drive it with two of these drivers which I am planning to drive in parallel to power the SBT90.2 up to 16 Amps:
FET 8x7135 Driver Board from K...n

Means: every 28650 cell is getting an own driver witch is wired up to the switch.

Are there any constraints/ problems to do so before I frie everything up?!

Thanks ahead
Frank

[desert.snake]

Just need to monitor the LED temperature, if the switches used can handle 16 amps.

[firstlordofthefire]

Just need to monitor the LED temperature, if the switches used can handle 16 amps.

thanks a lot for your fast reply! I will mod fhe original switch and hope for the best in terms of my heatsink (I will glue the chip directly onto my sink without a star with silver 2k glue)!

I will post some pictures when I am done!