After 3D printing some Lantern kits for various Maglites, I decided to make one for the old angle head Fulton MX991 "moonbeam".
It gives off a decent amount of light with the 55 lumen Nite Ize LED drop-in.
The kit consists of a diffuser that is attached to the light using the plastic ring that holds the colored filters in place and a base that slides on to the clip that keeps the light from tilting.
It gives off a decent amount of light with the 55 lumen Nite Ize LED drop-in.
The kit consists of a diffuser that is attached to the light using the plastic ring that holds the colored filters in place and a base that slides on to the clip that keeps the light from tilting.