sure thing- take the bulb module(pt) and remove the bottom board with a Knife carefully and save that switch
now set aside the reflecter . take the bulb out and put wires in it place thiner the better 1 inch or so long. solder them in . now get the reflector and enlarge the bulb hole to 3/8 or so. its more presise if you drill from the shiny side down.
now take your ls and remove the optics and put them aside. remove the optics holder from the heat sync leaving the exposed lsled. carefully remove the ls heat the leads if you needto.
slide the ls led up into the 3/8 reflecter hole(watch those leads. you can figure out how far it needs to go up into the reflector as i cant explain it) now hold it in plase with hot glue going from the leds bottem to the side of the inside. now solder the wires to the ls put the bottem on including the "switch". dont break the clear pegs
now file down the bump on the optics and drop in the reflector.
done. man that was hard any questions?
do me the favor of telling me what you think