Quick question /Arc resistor size

Noxiousbt · Jun 21, 2004

My meter does not read precise enough to tell exact resistor size on a LS rev2 board. Soldered on the board, my meter reads .4 ohms, but that didn't sound right. Could someone kindly let me know for sure? I would appreciate it.
Thanks,
Brandon

Nerd · Jun 21, 2004

Uh... I would hazard a guess @ 0.15 ohms, but that's for current revision boards, not sure if that is actually the "rev2".

Noxiousbt · Jun 21, 2004

Any others?

springnr · Jun 21, 2004

Should be .15 ohms for .333mA

To check you can place both leads at one end of the resistor and take a measurement - this will give you the resistance of your meter leads touching the pad. Then measure across the resistor. Now subtract the first measurement from the second and you should come up close to .15 ohms.

Noxiousbt · Jun 21, 2004

Thank you both for your help I am greatfull. I forgot little stuff like that after a few year of not being in electronics.

Quick question /Arc resistor size

Noxiousbt

Newly Enlightened

Nerd

Flashlight Enthusiast

Noxiousbt

Newly Enlightened

springnr

Enlightened

Noxiousbt

Newly Enlightened

Similar threads

Latest posts