How do you open up the Q3?
- Thread starter code09
- Start date
Help Support Candle Power Flashlight Forum
nexro
Enlightened
Refer to this page: http://www.cones.free-online.co.uk/
Click on Torches then Nuwai Q3.
Click on Torches then Nuwai Q3.
beam_me_up
Enlightened
I learned the hard way that the torx screws to the belt clip also seem to be sealed with LocTite...I broke my torx bit trying to remove it! Not only that but I stripped the tiny screws so now it's there forever /ubbthreads/images/graemlins/smile.gif I will try it again with a new bit and the hot-water technique.
Anglepoise
Flashlight Enthusiast
The hot water did not work for me.
I chickened out when the sealed pouch started to melt.
What did work was gently playing a flame from a Micro Butane torch about 2 inches from the metal. And remember the Q III comes apart in 4 not 3 pieces.
Once apart, the epoxy residue cleans up with lacquer thiner.
It was reported in another thread that Acetone did not work on this type of epoxy.
I chickened out when the sealed pouch started to melt.
What did work was gently playing a flame from a Micro Butane torch about 2 inches from the metal. And remember the Q III comes apart in 4 not 3 pieces.
Once apart, the epoxy residue cleans up with lacquer thiner.
It was reported in another thread that Acetone did not work on this type of epoxy.
