clip for Nitecutter and Nuwai Q-III for BEZEL DOWN

stormchaser · Feb 17, 2005

any suggestions on how to carry a clip mounted Q-III or Nitecutter BEZEL DOWN? clip on clip??

jeepinpaul · Feb 17, 2005

I just measured the Q3 tail and it has a 0.095" OD. The front diameter where the clip is factory located is 1.05". I suggest you drill and tap new holes on the tailcap to allow for bezel-down carry. Don't forget to remove the tail-switch inerds before you start drilling. I might just do it myself, since you sparked my interest.

clip for Nitecutter and Nuwai Q-III for BEZEL DOWN

stormchaser

Newly Enlightened

jeepinpaul

Newly Enlightened

Similar threads

Latest posts