chimo
Flashlight Enthusiast
I got in on the Cree XLamp group buy a while back, so I figured it was time to finally do something with them! The host driver pill is an adjustable MiniPro from Lambda.
The Cree LED is just a little too large to allow the supply wires to wrap around the edges so I had to grind a bit off the corners. Note the copper under the plating.
I also removed the bottom solder contact pads so they wouldn't short against the heatsink.
A dry fit on the pill.
I used Arctic Silver and coated the corners to insulate the supply wires.
The backside. Regular MiniPro on the left, the adjustable one on the right.
A view of the same same pills from the top.
Beamshot - both are CreeUV XLamps. The one on the left was from an earlier mod and has an NX05 optic. The one on the right is the UV MiniPro in a MiniMag with a reflector. There is great spill with the reflector.
Same order as above but the MiniPro MiniMag now has an NX05 optic as well.
Thanks for looking.
Paul
The Cree LED is just a little too large to allow the supply wires to wrap around the edges so I had to grind a bit off the corners. Note the copper under the plating.
I also removed the bottom solder contact pads so they wouldn't short against the heatsink.
A dry fit on the pill.
I used Arctic Silver and coated the corners to insulate the supply wires.
The backside. Regular MiniPro on the left, the adjustable one on the right.
A view of the same same pills from the top.
Beamshot - both are CreeUV XLamps. The one on the left was from an earlier mod and has an NX05 optic. The one on the right is the UV MiniPro in a MiniMag with a reflector. There is great spill with the reflector.
Same order as above but the MiniPro MiniMag now has an NX05 optic as well.
Thanks for looking.
Paul