Jul 11, 2005 #1 Longbow Enlightened Joined May 15, 2004 Messages 591 Location Wisconsin, USA Contrary to previously posted info the torx bit required to service Q-III clip screws is T6, not T5. The T6 fits very tight but is the correct size.
Contrary to previously posted info the torx bit required to service Q-III clip screws is T6, not T5. The T6 fits very tight but is the correct size.
Jul 11, 2005 #2 A attowatt Enlightened Joined Apr 13, 2005 Messages 500 Location New Mexico You must have read my mind Longbow /ubbthreads/images/graemlins/grin.gif Been looking at this for the last week. I knew it was smaller than T8, but not how much smaller Thanks Jim
You must have read my mind Longbow /ubbthreads/images/graemlins/grin.gif Been looking at this for the last week. I knew it was smaller than T8, but not how much smaller Thanks Jim