3rd_shift
Flashlight Enthusiast
These need to be just like the b2eze and modamag versions for stars.
(I'm almost out of those now.)
These need to be nearly pure aluminum stock, not aluminum alloy.
The center donut hole needs to be bigger at around 8-10mm, not just 5.
But just blank disks that are already beveled at the bottom to get past that little lip at the bottom of the inside of the head.
Just so that it will in fact make touchdown on the bottom landing inside the head as well as the sides.
I have had to use a dremel to bevel these sinks so far.
Proper, tight fit of the sinks is what allowed me to go guts out to make that MiniMonsterQuad in another thread.
I want to make more.
Others probably would like to have a go at that too.
I wouldn't be your only customer I don't think.
(I'm almost out of those now.)
These need to be nearly pure aluminum stock, not aluminum alloy.
The center donut hole needs to be bigger at around 8-10mm, not just 5.
But just blank disks that are already beveled at the bottom to get past that little lip at the bottom of the inside of the head.
Just so that it will in fact make touchdown on the bottom landing inside the head as well as the sides.
I have had to use a dremel to bevel these sinks so far.
Proper, tight fit of the sinks is what allowed me to go guts out to make that MiniMonsterQuad in another thread.
I want to make more.
Others probably would like to have a go at that too.
I wouldn't be your only customer I don't think.