bigchelis
Flashlight Enthusiast
Hi all,
Today I was trying to fit 2 18650's in my 2C ROP build. I already ordered the fivemega deep/wide tail cap, but figured I would try this differently....
If you remove the stock spring and put a PVC pipe from hardware store (cell holder) then put tail back on = it works perfectly. No rattle and everything fits super snug.
What are the drawbacks of using it this way????
If there are potential issues I can put the stock spring back in, but stick it all the way down and super short. It will be a super tight fit, but I can make it happen.
Any thoughts?
Notice how much the 2 18650's stick out, yet the stock tail cap fits perfectly snug.
Today I was trying to fit 2 18650's in my 2C ROP build. I already ordered the fivemega deep/wide tail cap, but figured I would try this differently....
If you remove the stock spring and put a PVC pipe from hardware store (cell holder) then put tail back on = it works perfectly. No rattle and everything fits super snug.
What are the drawbacks of using it this way????
If there are potential issues I can put the stock spring back in, but stick it all the way down and super short. It will be a super tight fit, but I can make it happen.
Any thoughts?
Notice how much the 2 18650's stick out, yet the stock tail cap fits perfectly snug.
Last edited: