i'm using Diodes Inc. driver chip AL8861 to drive 2 LEDs per string.
they recommend 4.7 to 10uF cap.
"The minimum capacitance needed is determined by input power, cable's length and peak current. 4.7μF to 10μF is a commonly used value for most cases. A higher value will improve performance at lower input voltages, especially when the source impedance is high."
my input voltage can be as low as 10 volts. LEDs are no more than 2" away from driver. peak current is 1amp.
i've been using 10uF caps but they have greatly increased in price.
when they say "improve performance", does that mean running at lower required current?
can i safely use 4.7uF caps?
thanks
they recommend 4.7 to 10uF cap.
"The minimum capacitance needed is determined by input power, cable's length and peak current. 4.7μF to 10μF is a commonly used value for most cases. A higher value will improve performance at lower input voltages, especially when the source impedance is high."
my input voltage can be as low as 10 volts. LEDs are no more than 2" away from driver. peak current is 1amp.
i've been using 10uF caps but they have greatly increased in price.
when they say "improve performance", does that mean running at lower required current?
can i safely use 4.7uF caps?
thanks