Re: FS:Nickel plated Copper P60 modules. XHP-70 3000+ OTF lumen!
The link provided doesn't work.
I have replaced it. Perhaps it will work now? Maybe I was logged in as admin?
whats a good host for this?
I use a bore out Surefire 6P with a solarforce body extension my self. Probly some of the above listed setups are better though.
Perhaps a silly question: do you sell drop-ins for the Convoy S2+? Thanks. Also clarification on the P60 drop-ins: I have read copper foil without adhesive is superior for heat transfer, what is your opinion?
I dont make a straight dropin for the S2+ but I do have custom S2+ available in my shop. Triple XPG3 etc.
http://asflashlights.com/35-pocket-lights-edc
I think copper foil helps. This bulb is desinged to make contact near the top where the "V" shape part of the bulb is. You could put copper tape around the lower part for better transfer, just make sure the tape does not stop the bulb from being pressed all the way down so the "V" makes contact.
A quick question..
Some of the XHP70 emitter photo here looks like they are shaved/dedomed.. Is that the case?
I don't know if any of the ones in the pics are like that or not. So far I only remember ever doing one like that. It did work quite well though. The beam did develop a bit tighter hot spot and some throw.
I suppose I can add that as an option to the listing.
Are the FET drivers used in conjunction with the Adventure sport and Dr Jones drivers or are they a seperate driver option itself?
I want the brightest dropin option as possible. [emoji41]
The driver in all my lights is a Mosfet. This means the emitters are essentially direct drive for maximum output. Either of the 2 user interfaces can be applied to the micro chip. Neither has any effect on max output, only on what the lower modes will be.
