Dukester
Flashlight Enthusiast
My 4D M@G fell bezel first on to a concrete floor from say a 28 to 34" height. The low output bulb survived, checked filament with magnifying glass and it is still intact. Tried my High Ouput bulb after double checking the integrity of the filament, checked out ok but still no light. I took my DMM and I am not getting a voltage reading from the pedestal after placing the hot wire of the DMM into the pedestal and using the ground of the DMM to ground against the body of the M@G and I am not getting a reading, Any ideas???
Thanks,
Dave
Thanks,
Dave