Recent content by LEDburn

fenix-store
  1. L

    Reylight brass only brass coated?

    From everything I have read and personally experienced, brass is actually a better conductor of electricity than aluminum but you are right that it conducts heat worse than aluminum. Copper is a better conductor of both heat and electricity than either brass or aluminum. Thermal conductivity...
  2. L

    Fenix LD10 Issues.....!!!

    Fixing it yourself will save you both time and money. Sending it away when you can fix it yourself is a waste of money. But then again, some chumps just don't have the skills to fix things themselves. ..not everyone's like you mate ;) Edit: straight from the horses mouth - warranty will not...
  3. L

    Did I Kill My Zebralight

    Oh really? Last time I went exploring there was about a dozen people from mixed backgrounds and only a few people knew each other at the start of the trip. Throughout our journey in the tunnels and drains under the city I managed to notice a few people had ZL's (which I started talking about...
  4. L

    Anyone considering buying a P60 drop-in off Amazon should see this.

    http://flashlightguide.com/2013/05/review-malkoff-m361n-lmh-drop-in/ Gee, the regulation on that Malkoff sure sucks :rolleyes: Output seems pretty flat until, wait for it…until the battery is almost flat (who woulda thunk) at which time it drops in output so you can tell it is almost flat...
  5. L

    Anyone considering buying a P60 drop-in off Amazon should see this.

    So what if it drops out at 3.4V? Would you prefer it to maintain full brightness until it suddenly dies due to a protected battery calling it quits? One minute you're flying down a trail on your bike at night, next the light cuts out and *CRASH* Personally I like to know my torch is dimming a...
  6. L

    MaratacVN AAA Copper Light

    That's ok. Paypal sent for 1 x BRASS with swap to XP-E2 cool white + international shipping.
  7. L

    MaratacVN AAA Copper Light

    Still in for a cool white XP-E2 but not sure if I want 219B or not.. Do you have or can you get cooler XP-L's by any chance? I'm looking for something around 6200K..
  8. L

    Insight LED Lights? Any Good? Who Has one of these?

    I think you'll find many people don't usually buy Surefire for their lumens output. Some will claim the warranty, customer service and reliability are the reasons. You have to also remember that their torches are not that poorly performing when you think about it - they may not have the highest...
  9. L

    I want a tiny terror which one should I get?

    While those are certainly awesome lights, the high output is merely a novelty if you have any intention or need for prolonged usage. If you're into tiny lights that are brighter than anything else that size, they may appeal to you, however for the OP, I believe something running 18650's will be...
  10. L

    The Official Malkoff Junkie thread - Part 2

    I bet you're using Chrome!? Try another browser ;)
  11. L

    10,000 lumens Supbeam X60M(CREE MT-G2 q0)

    I was under the assumption LED lumens were possible calculated lumens based upon the expected circuit conditions compared to the LED data sheets provided by manufacturers. Thus termed CALCULATED lumens. I was also under the impression that OTF lumens are OTF lumens… :shrugs: Using an...
  12. L

    Foursevens Bolt Action light - early opinions?

    Modes seem ridiculous and over the top for it's size and power source. My P2 gets hot quite fast and it's running less than half the output!! Chewing through CR2's will only be sustainable by those with a chunk of disposable cash. Based on that and what everyone else has said, I feel this is...
  13. L

    MaratacVN AAA Copper Light

    The brass ones are still available which is what I am after or did you mean you aren't doing another order till next year? http://www.countycomm.com/aaabrass.html
  14. L

    MaratacVN AAA Copper Light

    Merry Christmas from Australia :-) Do you have any of these on hand or do you have to order them first? I'm after one brass with a 219B and another brass with a XP-E2 cool white… is it also possible to grab an unmodified black cheapie as a keyring beater?
  15. L

    Preon AAA with clicky problem

    Sounds like you could be experiencing the same or a similar issue to what I had when I got my Toxic Green P1 and clicky tailcap a few weeks ago. Maybe not as mine seems a little different.. Basically, my tapcap was constantly popping out of the clicky housing (the part that screws into the...
See more

Latest posts

Top